EPEVER SOLAR CHARGE CONTROLLER SETUP: TRACER AN SERIES CONTROLLE

EPEVER SOLAR CHARGE CONTROLLER SETUP: TRACER AN SERIES CONTROLLE

Blog Article

The EPEVER Tracer AN Series Photo voltaic Cost Controller is really a hugely economical solar controller made for off-grid photo voltaic systems. Based upon multiphase synchronous rectification engineering, it makes certain optimized Power conversion and program steadiness for a wide range of photovoltaic (PV) programs.

Crucial Characteristics of your EPEVER Tracer AN Series Controller
The Tracer AN series makes use of EPEVER Photo voltaic Demand Controller technological know-how for exceptional solar Strength harvesting. Crucial characteristics include:

Multiphase Synchronous Rectification (MSR) for enhanced Power conversion.
Sophisticated MPPT Algorithm with >99% efficiency.
Twin-Phase Charging for Increased battery everyday living.
Liquid crystal display Exhibit with authentic-time facts checking.
A number of Load Management Modes which include guide and timer.
Detailed Electronic Protections against overcharging, in excess of-discharging, limited circuits, and reverse polarity.
Phase-by-Phase Guide to Putting together the EPEVER Tracer AN Sequence Controller
1. Unboxing and Getting ready the Controller
Make sure all components are bundled: Tracer AN device, temperature sensor, conversation cables, and consumer manual.
Verify the product range and voltage ratings match your photo voltaic panel and battery specs.
2. Mounting the Demand Controller
Pick out a properly-ventilated, dry spot near to the battery lender.
Protected the Tracer AN controller using the provided mounting brackets.
Keep appropriate clearance for heat dissipation.
three. Wiring the Photo voltaic Cost Controller
Caution: Normally observe appropriate protection protocols and make sure the program is driven off prior to connecting components.

Move one: Hook up the battery terminals to the charge controller (favourable to beneficial, detrimental to damaging).
Action 2: Connect the photo voltaic panel array to your PV input terminals.
Phase three: Link the load terminals if employing a direct load connection.
Move 4: Double-check all connections for polarity and tightness.
four. Configuring the Controller Options
Energy over the controller by connecting the battery initially.
Use the Liquid crystal display Display screen to navigate the options menu.
Configure:
Battery Variety: AGM, GEL, Flooded, Lithium.
Charging Parameters: Absorption voltage, float voltage.
Load Manage Modes: Handbook, timer, gentle control.
five. Monitoring and Data Logging
The Tracer AN Collection supports actual-time monitoring using the MT50 distant meter.
Knowledge may be logged by using the RS485 conversation port using program for example Solar Station Personal computer.
Remote checking is possible While using the EPEVER WiFi module.
six. Troubleshooting Typical Difficulties
Situation one: No Energy Output

Test battery voltage and connections.
Confirm PV panel voltage exceeds battery voltage.
Problem two: More than-Voltage Defense

Verify the photo voltaic array’s voltage rating.
Change program parameters if necessary.
Situation three: No Battery Charging

Inspect PV wiring for continuity.
Validate MPPT configurations while in the menu.
Benefits of the Tracer AN Sequence with MSR Technology
The multiphase synchronous rectification technological innovation ensures:

Larger Performance: Lowered Electricity losses throughout conversion.
Increased Reliability: Steady general performance under variable loads.
More time Battery Life: Steady and exact charging More info profiles.
Conclusion
The EPEVER Solar Demand Controller with multiphase synchronous rectification technologies is surely an Extraordinary option for optimizing solar power technology and increasing battery lifestyle. By pursuing the above mentioned setup information, buyers can make sure greatest performance and method longevity.